Misc. Mods to the inner tray for easier fit.

The inner tray of the pan needs a litle tweaking to make it easier to align all the holes during installation.

At top of the pan, there is a recess into the pan and the inner tray touches it. You only need to remove about 1/32" of material, just enough for tray to move easily.
This shows the slight arc carved into the steel with dremel type tool.

By adding this clearance to the oil pick up tube, you make it easier to align the bolt holes during installation.

It is really tight fit as delivered, but with 1/16" taken off each side as noted and slight bit along the whole length, it makes install much quicker.

Note horizontal dimension from inner wall
Note width of the slot after bit of massaging.